2. Before connecting electrical consumers, carry out the following:
■ Determine the consumption values of the electric consumers.
■ Do not exceed the maximum system load caused by electric consumers. If necessary, re‐
duce the number of connected consumers.
■ Read the technical specification for the generator before connecting voltage-sensitive
equipment.
■ Check that electrical consumers and their connecting cables are in perfect condition.
■ Plug in and switch on consumers one-by-one.
■ Consumers with unfavourable on/off characteristics (e.g. high starting current) should be
started first.
Do not allow the rated current for each electrical socket and for the generator to be excee‐
ded.
8.8.3 Switching off the generator
Before deactivating the generator, carry out the following:
■ Switch off electrical consumers and unplug them one-by-one.
■ Switch off consumers drawing the highest current last.
■ Check that the protective covers on the power sockets are correctly closed.
1.
NOTICE!
Thermal overload of the turbo generator.
Stopping the machine abruptly after the generator has been in operation for some time can
cause heat damage to the generator.
➤ Allow the engine to run for about 2 minutes in idle before shutting down to allow the gener‐
ator to cool down.
2. Set the «automatic circuit breaker(s)» to the "0" position.
3. Turn the «generator main switch» to the "0" position.
4. Close all «compressed air outlet valves» on the air distributor.
The engine runs in IDLE and the generator can cool down.
After running about 2 minutes in IDLE, the generator has cooled down sufficiently for the en‐
gine to be stopped.
8.9 Cleaning the machine after operation
Material High-pressure cleaner
Precondition The machine is switched off.
The machine has cooled down.
The machine is fully vented, the pressure gauge reads 0 bar.
All compressed air consumers are disconnected and the air outlet valves are open.
Maintain the following minimum distances to the object to be cleaned in order to prevent damages
to the machine when cleaning with the high-pressure cleaner.
■ Circular section jets: approximately 70 cm
■ Fan jets: approximately 30 cm
■ Dirt blasters: approximately 30 cm
8
Operation
8.9
Cleaning the machine after operation
No.: 9_5898 26 E
Operator manual Portable compressor
M 64
81
RAMIRENT
