K-sun Green Machine, User Manual

Page: 116 / 142

110
Appendix
Messages On the Display
When an error message appears
Sample screens shown below may vary depending on the display pattern.
Error message Cause and Remedy
The batteries have run out. Turn the power off and replace all the
batteries with new AA alkaline batteries. Also, make sure that the
batteries are inserted with correct polarity. It is recommended that
you use the AC adapter that comes with the product as much as
possible.
See
"Connecting the bundled AC adapter" (p.
18
).
See "Installing the batteries" (p.
18
).
See "Setting battery type" (p.102).
The top cover is opened and the power is automatically turned off.
Close the top cover and turn on the power again.
The tape cartridge is not installed or not installed correctly.
Turn the power off and reinstall the tape cartridge correctly.
See
"Installing tape cartridges" (p.
21
).
Tape cartridge that is not supported by the K-Sun
®
GREEN
MACHINE
®
, is installed, or the cartridge is installed incorrectly.
Turn the power off and check the cartridge and replace it if
necessary.
See
"Installing tape cartridges" (p.
21
).
The printhead is overheated due to the continuous printing.
Turn the power off, remove the tape cartridge, and leave the device
until it cools down.
The text you entered is too much to print for the tape
cartridge
you
selected
. Press any key to return to the text enter screen
and delete all text in the line indicated by , or reduce the line by
the line setting. See "Adding New Lines (Line Break)" (p.44).
The tape cartridge for Telecom/Electrical Label can not display
printing or preview, because the tape length is not set. Set the tape
length wider or longer.
See "Creating the label in Telecom/Electrical Label Mode" (p.5
2
).