Jungheinrich ETM/V 214, Operating Instructions Manual

Page: 78 / 97

E 37
1003
.GB
Keypad Fault Messages
The following faults are shown by the LED (65) flashing red:
– New master code is already the operator code
– New operator code is already the master code
– There is no operator code to be altered.
– Operator code to be changed to another operating code which already exists.
– No operator code to delete.
– Code memory full
8 Changing Truck Parameters
F
Changing the truck parameters affects the travel pattern of the truck. This must be
taken into account when starting the truck again.
Parameters may only be changed when truck is standing and no lifting operations are
in progress.
With the driver display (
t
) or the on board computer (
o
) it is also possible to change
certain truck parameters and hence the truck behaviour (acceleration, rollout brake,
reverse brake, drive direction travel speed, fork direction travel speed and lift speed).
t
Trucks with driver display and ignition switch
On trucks with an ignition switch use the grey service key in order to access the travel
and lift parameters.
o
Trucks with driver display and CANCODE or on board computer
Z
Before entering the SERVICE MENU / PARAMETER MENU you will be asked for
your PIN. Trucks with CANCODE (
o
) are factory set with PIN 2580 or if they have an
on board computer (
o
) PIN 14037 .
To switch the truck on enter the allocated PIN. You will then not be requested to
produce the PIN before entering the SERVICE MENU / PARAMETER MENU. The
parameter settings are saved in the PIN memory.
It is possible to have 15 individually programmable parameter settings (truck or
programme change). In order to select other programme settings the truck must be
logged off and on logged on again or switched on and off. Enter next PIN.
M
Changes to the service mode may only be undertaken by the manufacturer’s
authorised service engineers!
E 37
1003
.GB
Keypad Fault Messages
The following faults are shown by the LED (65) flashing red:
– New master code is already the operator code
– New operator code is already the master code
– There is no operator code to be altered.
– Operator code to be changed to another operating code which already exists.
– No operator code to delete.
– Code memory full
8 Changing Truck Parameters
F
Changing the truck parameters affects the travel pattern of the truck. This must be
taken into account when starting the truck again.
Parameters may only be changed when truck is standing and no lifting operations are
in progress.
With the driver display (
t
) or the on board computer (
o
) it is also possible to change
certain truck parameters and hence the truck behaviour (acceleration, rollout brake,
reverse brake, drive direction travel speed, fork direction travel speed and lift speed).
t
Trucks with driver display and ignition switch
On trucks with an ignition switch use the grey service key in order to access the travel
and lift parameters.
o
Trucks with driver display and CANCODE or on board computer
Z
Before entering the SERVICE MENU / PARAMETER MENU you will be asked for
your PIN. Trucks with CANCODE (
o
) are factory set with PIN 2580 or if they have an
on board computer (
o
) PIN 14037 .
To switch the truck on enter the allocated PIN. You will then not be requested to
produce the PIN before entering the SERVICE MENU / PARAMETER MENU. The
parameter settings are saved in the PIN memory.
It is possible to have 15 individually programmable parameter settings (truck or
programme change). In order to select other programme settings the truck must be
logged off and on logged on again or switched on and off. Enter next PIN.
M
Changes to the service mode may only be undertaken by the manufacturer’s
authorised service engineers!