D 5
1003
.GB
5
Removing and Fitting the Battery.
– Expose Battery (see Section 3).
F
In order to avoid a short circuit, exposed poles or connections must be covered with
an rubber cover. When using a crane to change the battery ensure that there is
sufficient lifting capacity (see battery weight on the battery data plate fitted to battery
holder). The lifting harness must exert a vertical pull so that the battery holder is not
crushed. Hooks shall be fitted so that when the sling chains are slackened off they do
impinge on the battery cells.
Removal and Installation using a Lifting Harness
– Loosen fixing bolts (9) in the red battery retaining bracket (8)
– Remove retaining bracket (8).
– Couple lifting harness to battery holder (7).
– Lift the battery clear and move out to the side.
Dismantling and assembling with battery trolley (
o
)
F
The truck must lie horizontally so that when removing the battery retaining bracket the
battery itself does not roll out.
– Loosen fixing bolts (9) in the red battery retaining bracket (8)
– Remove retaining bracket (8).
– Lift the battery to the side on to the battery trolley
Installation to be carried out in reverse order.
F
When changing the battery it may only be replaced by one of similar design. Following
installation the cable and connections must be visibly checked for damage and cover
plates must be replaced securely.
7
9
8
D 5
1003
.GB
5
Removing and Fitting the Battery.
– Expose Battery (see Section 3).
F
In order to avoid a short circuit, exposed poles or connections must be covered with
an rubber cover. When using a crane to change the battery ensure that there is
sufficient lifting capacity (see battery weight on the battery data plate fitted to battery
holder). The lifting harness must exert a vertical pull so that the battery holder is not
crushed. Hooks shall be fitted so that when the sling chains are slackened off they do
impinge on the battery cells.
Removal and Installation using a Lifting Harness
– Loosen fixing bolts (9) in the red battery retaining bracket (8)
– Remove retaining bracket (8).
– Couple lifting harness to battery holder (7).
– Lift the battery clear and move out to the side.
Dismantling and assembling with battery trolley (
o
)
F
The truck must lie horizontally so that when removing the battery retaining bracket the
battery itself does not roll out.
– Loosen fixing bolts (9) in the red battery retaining bracket (8)
– Remove retaining bracket (8).
– Lift the battery to the side on to the battery trolley
Installation to be carried out in reverse order.
F
When changing the battery it may only be replaced by one of similar design. Following
installation the cable and connections must be visibly checked for damage and cover
plates must be replaced securely.
7
9
8
Summary of Contents for ETM/V 214
