Jungheinrich ETM/V 214, Operating Instructions Manual

Page: 75 / 97

1003
.GB
E 34
7.3 Parameter Settings
The master code must be entered to change the truck setting.
Z
The factory setting for the master code is 7-2-9-5.
M
Change the master code when starting the truck for the first time (see Section 7.1).
Entering the master code:
– Press the
o
key
– Enter the master code
Code Key Parameters
Setting procedure for truck:
– Enter the three digit parameter number, confirm with the Set key (66).
– Enter the set value according to parameter list or change and confirm with Set key
(66).
Z
If an unauthorised number is entered the LED (65) of the
o
switch (70) will flash red.
When the parameter number is entered again the set value can be entered or
changed.
Repeat the procedure to enter additional parameters. When input is complete press
the
o
key (70).
1003
.GB
E 34
7.3 Parameter Settings
The master code must be entered to change the truck setting.
Z
The factory setting for the master code is 7-2-9-5.
M
Change the master code when starting the truck for the first time (see Section 7.1).
Entering the master code:
– Press the
o
key
– Enter the master code
Code Key Parameters
Setting procedure for truck:
– Enter the three digit parameter number, confirm with the Set key (66).
– Enter the set value according to parameter list or change and confirm with Set key
(66).
Z
If an unauthorised number is entered the LED (65) of the
o
switch (70) will flash red.
When the parameter number is entered again the set value can be entered or
changed.
Repeat the procedure to enter additional parameters. When input is complete press
the
o
key (70).