Jungheinrich ETM/V 214, Operating Instructions Manual

Page: 30 / 97

C 5
1003
.GB
Moving the truck without a battery
– Withdraw battery plug.
– Push driver’s seat out of the guide towards the steering wheel.
– Remove fan plug from seat hood.
– Remove seat hood (see Chapter F).
– Remove two-pin plug from magnetic brake
– Remove the brake release screws from the drive plate and insert them into the
holes in the magnetic brake.
Z
The brake is now ventilated without current. The vehicle can be pushed or pulled
without the battery.
M
After pushing operation is complete the brake release screws must be removed
again.
– Remove the brake release screws from the magnet brake and insert them into the
holes in the drive plate.
– Connect the two-pin plug to the magnet brake.
– Re-fit hood.
– Connect the fan plug to the seat hood.
– Position driver’s seat in guide.
– Connect battery plug.
– Switch on the main switch and key switch
Z
The truck is now ready for use.
5 Commissioning
F
Before commissining the machine ensure that the hydraulic hoses to the main unit/
hoist frame interface have been connected.
M
Operate the truck only with battery power! The AC current of the rectifier will damage
electrical components. Connecting cables to the battery (trailing cables) must be less
than 6 metres.
To prepare the machine after delivery or transport the following tasks must be carried
out:
– Install battery (where required). Do not damage battery cable.
– Charge up the battery (see Chapter D).
– Where necessary remove the transport lock for the safety brake
– Operate the truck as described above. (see Chapter E).
Z
If delivered without a battery the truck can only be steered by means of the
mechanical back-up system (see Chapter E).
Z
After commissioning it is possible that slight brake scrubbing noises will be heard.
C 5
1003
.GB
Moving the truck without a battery
– Withdraw battery plug.
– Push driver’s seat out of the guide towards the steering wheel.
– Remove fan plug from seat hood.
– Remove seat hood (see Chapter F).
– Remove two-pin plug from magnetic brake
– Remove the brake release screws from the drive plate and insert them into the
holes in the magnetic brake.
Z
The brake is now ventilated without current. The vehicle can be pushed or pulled
without the battery.
M
After pushing operation is complete the brake release screws must be removed
again.
– Remove the brake release screws from the magnet brake and insert them into the
holes in the drive plate.
– Connect the two-pin plug to the magnet brake.
– Re-fit hood.
– Connect the fan plug to the seat hood.
– Position driver’s seat in guide.
– Connect battery plug.
– Switch on the main switch and key switch
Z
The truck is now ready for use.
5 Commissioning
F
Before commissining the machine ensure that the hydraulic hoses to the main unit/
hoist frame interface have been connected.
M
Operate the truck only with battery power! The AC current of the rectifier will damage
electrical components. Connecting cables to the battery (trailing cables) must be less
than 6 metres.
To prepare the machine after delivery or transport the following tasks must be carried
out:
– Install battery (where required). Do not damage battery cable.
– Charge up the battery (see Chapter D).
– Where necessary remove the transport lock for the safety brake
– Operate the truck as described above. (see Chapter E).
Z
If delivered without a battery the truck can only be steered by means of the
mechanical back-up system (see Chapter E).
Z
After commissioning it is possible that slight brake scrubbing noises will be heard.