Jungheinrich ETM/V 214, Operating Instructions Manual

Page: 60 / 97

E 19
1003
.GB
Placing, Lifting and Transporting
Load Units
– Set forks to the horizontal position:
Press rocker switch (31), rocker (V) or
(R).
– Approach the load unit
– Extend the mast holder. Tilt Multi-Pilot
(3) in direction (T).
– Lift fork prongs to correct level: Pull
Multi-Pilot (3) in direction (H).
– Position forks under the load
– Lift load freely: Pull Multi-Pilot (3) in
direction (H).
– To retract mast holder: Tilt Multi-Pilot
in direction (U).
F
Only transport the truck with or without a load when the mast holder is retracted, the
lifting frame tilted back and the load pickup device lowered.
– Lower load unit in the transport position: Press Multi-Pilot (3) in direction (S).
– Tilt the load unit back: Press rocker switch (31), rocker (R).
– Transport load unit.
– Position the load horizontally: Press rocker switch (31), rocker (V).
– Set the load to correct height: Pull Multi-Pilot (3) in direction (H) and if necessary tilt
the Multi-Pilot in direction (T) to extend the mast holder.
– To lower the load: Press Multi-Pilot (3) in direction (S).
– To retract the mast holder: Tilt Multi-Pilot (3) in direction (U).
3
H
S
U
T
E 19
1003
.GB
Placing, Lifting and Transporting
Load Units
– Set forks to the horizontal position:
Press rocker switch (31), rocker (V) or
(R).
– Approach the load unit
– Extend the mast holder. Tilt Multi-Pilot
(3) in direction (T).
– Lift fork prongs to correct level: Pull
Multi-Pilot (3) in direction (H).
– Position forks under the load
– Lift load freely: Pull Multi-Pilot (3) in
direction (H).
– To retract mast holder: Tilt Multi-Pilot
in direction (U).
F
Only transport the truck with or without a load when the mast holder is retracted, the
lifting frame tilted back and the load pickup device lowered.
– Lower load unit in the transport position: Press Multi-Pilot (3) in direction (S).
– Tilt the load unit back: Press rocker switch (31), rocker (R).
– Transport load unit.
– Position the load horizontally: Press rocker switch (31), rocker (V).
– Set the load to correct height: Pull Multi-Pilot (3) in direction (H) and if necessary tilt
the Multi-Pilot in direction (T) to extend the mast holder.
– To lower the load: Press Multi-Pilot (3) in direction (S).
– To retract the mast holder: Tilt Multi-Pilot (3) in direction (U).
3
H
S
U
T