D*AP8
30
You must use the scroll bar to navigate through the matrix. In the upper left corner you can select between
the
ONAIR
and the
PRESETS
view of the matrix. On the
ON AIR
page you will also see the device signal
labels (see ROUTING section further below for details).
Channel Linking
[mono / stereo]
You can decide if the routing must be performed in mono or stereo mode
(where adjacent odd/even channels are routed at once).
You may select cross points by hovering with the mouse over the little squares and select / deselect cross
points with a left mouse button click. The color of the respective squares changes:
Mouse over
Color codes of cross points:
dark blue
Possible new cross point.
orange
You are about to reconnect a cross point.
grey
Cross point is not allowed (i.e. routing will cause a loop and will not
therefore be performed) or dedicated input is not activated.
red
You are about to disable a cross point
An animated signal flow will help you when navigating through the matrix.
Setup GUI – INTERFACES – SDI I/O interface –
Setup
SDI Bypass
SDI Relay Bypass
Will deactivate the
Bypass
Relay
. It provides a shortcut from
SDI-IN
to
SDI-OUT1
and
disconnects the de-embedder
from the SDI input. This relay
also serves as a
fail bypass
if
the power is off. This feature
maintains the SDI signal for
downstream equipment.
SDI Embedder
Will pass the embedded audio
Bypass
data from the de-embedder to the
embedder 1:1. This function
preserves the original
Ancillary Data structure.
Video Delay
Video Delay
[0 … 15]
(frames)
For compensation of any kind of
audio processing delay within the
chain of devices you may use a
Video Delay
. Position “0” turns
off the delay function.
