D*AP8
9
Select item "8: Reboot"
<ENTER>
Do you want to reboot the device ?
Press small
"y" <ENTER>
Rebooting the device ……..
After reboot has finished, the new IP configuration is active and will be displayed at the top of the
configuration menu.
Getting started – IP setup of the
D*AP8
–
via web browser
* Read the
default IP address
printed on a label at the rear of the device.
* Set up network parameters of your PC to fit the default IP address of the
D*AP8 unit
(e.g. default IP + 1 and net mask = 255.255.0.0).
* Connect the
D*AP8
with the PC either via an Ethernet patch cable (if the PC
supports Auto-MDI(X), an Ethernet cross over cable or via patch cables with a switch.
* Open a browser and type the IP address of the
D*AP8
into the URL field and press
<ENTER>
.
This will open the
AUDIO PROCESSOR
tab sheet of the GUI.
* Click on
<SYSTEM>
and afterwards the
<Admin>
tab:
Enter the desired network configuration and press
<apply>
Afterwards you must reboot the
D*AP8
in order to activate the new IP configuration.
Important Note!
After reboot neither the
web browser
nor the
X*AP RM
1
remote panel will be able to
communicate with the
D*AP8 unit
. You must fill in the new IP address in the URL field and change
the
X*AP RM
1
remote panel settings to attach this device with its new IP address.
