D*AP8
27
Setup GUI – INTERFACES –
AES I/O
Status
[green / red / yellow] The soft LED represents the status
Input Signal Status
[OK / Fail]
Fail = no carrier, unlock, cranky [too much jitter]
Input Signal Type
[Mute / PCM / Non PCM]
The
Non PCM
(e.g. Dolby encoded signal) status will be retrieved
from a logical combination of the Validity flag and the channel
status.
Important Note!
The input signal status is logically combined and represented as part of the
System Status. If one of the inputs is not assigned by the ROUTING matrix, its status will not be
incorporated into the System Status. If non of the inputs is routed the Interface Status > AES I/O status soft
LED becomes grey.
Settings
Enable Relay Bypass
[ON / OFF]
For fail save operation bypass relays are provided to connect
AES IN / OUT in case of a power fail. One may enable such relays
manually here.
Input Sample Rate
[ON / OFF]
Converter
For asynchronous sources it is possible to turn a
SRC
on.
If an
SRC
is turned on and the input status becomes
Non-PCM
, the
SCR
will be turned OFF automatically in order to maintain the
original data structure of the encoded bit stream (e.g. Dolby E).
Output Channel Status
[Transparent / Prof PCM / Prof Non-PCM / Cons PCM /
Cons Non-PCM]
The channel status can either be transparent from the
input source of the
D*AP8
or may be overwritten.
