D*AP8
16
System Messages
<current> / <history>
Displays a list of messages produced by the system controller.
System Log
The system controller activities will be logged. If there is a suspicious
behavior we recommend to warm-start the D*AP8 by pressing the rear
<INIT / RESET>
button briefly. This will keep the log information for later
investigation. If you do a power cycle instead the previous
log information get lost.
<save diagnostics file>
Pressing this soft button will start the assembly of files to help with
diagnostics. The packed
.tar
archive contains 3 files:
The console log from the System Status pane, the license file and the
status XML If you experience unexpected behavior of the device you may
be asked by the Junger service team to send such file by e-mail for
analysis.
Setup GUI – SYSTEM –
Overview
The graphical overview shows the main building blocks of the device including options installed,
in this example a
SDI
interface placed into the interface 1 location and a
JDSPA
co-processor as well as the
Dolby
CAT1100
OEM module, that runs the Dolby decoder / metadata emulation and a Dolby E encoder.
A fully loaded unit can have a Dolby (D / D+ / E / PL II) decoder / metadata emulator including a PL II encoder
and up to two independent Dolby E encoders or one Dolby E and two consumer (Dolby D / D+ / AAC) format
encoders installed.
You may click into the boxes and the respective page will open. The navigation is based on URLs so you may
use the
<Back>
navigation button of the browser to return to this page.
