Chapter 4 _________________________________________________________________ Operation
JUMO __________________________________________________________________________ 97
Using Serial Line
SERI
Use the serial line command
SERI
[
b p d s
] to set communication
settings for the user port.
SERI
[
b p d s
]
where
b
=
Bit rate (110, 150, 300, 600, 1200, 2400, 4800, 9600,19200,
38400, 57600, 115200)
p
=
Parity (n = none, e = even, o = odd)
d
=
Data bits (7 or 8)
s
=
Stop bits (1 or 2)
Example:
>SERI 600 N 8 1
600 N 8 1
>
You need to reset the transmitter to activate the new communication
settings set with command SERI.
The settings can be changed one parameter at a time or all parameters
at once:
>SERI O
changing parity only
4800 O 7 1
>SERI 600 N 8 1
changing all parameters
600 N 8 1
>
SMODE
Use the command
SMODE
to set the user port start-up operating
mode.
SMODE
[
xxxx
]
where
xxx =
STOP, RUN or POLL
