User's Guide _______________________________________________________________________
98 _______________________________________________________________________________
Table 25
Selection of Output Modes
Mode
Output
Available Commands
STOP
Only with the
SEND
command
All (default mode)
RUN
Automatic output
Only command S
POLL
Only with the
SEND
[
addr
]
command
Use with RS-485 buses, see
Operation of the RS-485 Module
on page 119.
Selected output mode will be activated after power outages.
INTV
Use the command
INTV
to set the outputting interval for the RUN
mode.
INTV
[
xxx yyy
]
where
xxx
=
Output interval (0 ... 255). 0: the fastest possible output rate.
yyy
=
Unit (s, min or h)
Example:
>INTV 10 min
Output intrv. : 10 min
>
ECHO
Use the command
ECHO
to set the user port echo. The command
either enables or disables echo of characters received.
ECHO
[
x
]
where
x
=
ON (default) or
=
OFF
NOTE
You can use the SERI, SMODE, INTV and ECHO commands to
change/view the user port settings even if you are currently connected
to the service port.
