JUMO 705003, Operating Manual, Page: 87 / 112

87
5 Configuration
Time operation
This function is available as of system version 7.
Time operation has higher priority compared with standard operation, but lower priority than event oper-
ation.
Recorded values
The following values are determined within a recording interval:
•
Current value (current value at the end of the interval)
• Measured value status (status of the current value according to NAMUR NE107)
• Minimum value (for digital signal: number of low values (logical 0))
• Maximum value (for digital signal: number of high values (logical 1))
• Average value (for digital signal: number of high values in relation to the number of low values)
• Number of values with measuring range underflow
• Number of values with measuring range overflow
• Number of valid value
• Number of invalid values
Post-trigger time
[s] 0 to 10 ( 0 ) Extends event operation after the control signal
has been deactivated.
Memory rate
[hh:mm:ss] 00:00:01 to 24:00:00
(
00:00:01 )
Recording interval
Time interval at which the values of the analog and
digital signals of the group are stored for evalua-
tion.
Parameter Selection/data input Description
Parameter Selection/data input Description
Start
[hh:mm:ss] 00:00:00 to 23:59:59
(
00:00:00 )
Time at which the time operation is started.
Start = End: Time operation is not active.
End
[hh:mm:ss] 00:00:00 to 23:59:59
(
00:00:00 )
Time at which the time operation ends.
Memory rate
[hh:mm:ss] 00:00:01 to 24:00:00
(
00:00:01 )
Recording interval
Time interval at which the values of the analog and
digital signals of the group are stored for evalua-
tion.