JUMO 705003, Operating Manual, Page: 86 / 112

5 Configuration
86
Digital channels
Standard operation
Event operation
This function is available as of system version 7.
Event operation has the highest priority of all three operating modes.
End of display
range -99999 to 99999 ( 100 )
As of system version 7:
-1.7e+307 to 1.7e+307
Upper limit of display range
Unit
(only with system
version 6) Select unit
(
No unit )
Value unit
As of system version 7, the unit of the input signal
is used.
Replace display
parameters Inactive
Active
If active:
Data evaluation: The original display parameters
are replaced by the display parameters used here.
As of system version 7:
Scaling type
Scaling of the y-axis
Linear Linear
Logarithmic Logarithmic
Parameter Selection/data input Description
Parameter Selection/data input Description
Input signal Select signal from selector Digital signal (binary signal)
System version 5: Digital PLC outputs (binary val-
ues 001 to 120) or signal from the event list (cen-
tral detector: active after each new alarm, inactive
after acknowledgement).
As of system version 6: Additional digital signals
available (process values of the modules).
As of system version 6:
Designation
Enter text (or use existing text) Designation of the signal
Replace designa-
tion Inactive
Active
If active:
Data evaluation: The original designation is re-
placed by the designation used here.
Parameter Selection/data input Description
Memory status Activation of data recording
On The data is recorded at the configured interval
Off Data recording is not active.
Memory rate
[hh:mm:ss] 00:00:01 to 24:00:00
(
00:00:05 )
Recording interval
Time interval at which the values of the analog and
digital signals of the group are stored for evalua-
tion.
Parameter Selection/data input Description
Control signal Select signal from selector Digital signal (binary signal) that starts (high ac-
tive) and stops event operation.