JUMO 705003, Operating Manual, Page: 81 / 112

81
5 Configuration
Setting of setpoint values: setpoint value units
5.8.3 Analog variables
These settings affect the use of the analog variables (analog PLC outputs) for functions that have been
implemented in the device firmware (e.g. data recording).
5.8.4 Digital variables
These settings affect the use of the digital variables (digital PLC outputs) for functions that have been
implemented in the device firmware (e.g. data recording).
5.9 PLC parameters
The configuration structures that were individually created using the CPV Editor (CPVE) are displayed
here.
This configuration data can be used in the setup program, in the web application, and in the CODESYS
application.
NOTE!
The CPV Editor requires specific knowledge and is intended for use by the manufacturer only (service
that is subject to a fee).
Parameter Selection/data input Description
Setpoint value 01
unit to
Setpoint value 30
unit Unit of the setpoint value concerned
No unit
Absolute temperature Temperature value
Relative temperature Temperature difference
Relative humidity Relative humidity
Ratio Ratio of two values A and B (A / B) in percent
Hours Hours
Minutes Minutes
Seconds Seconds
Parameter Selection/data input Description
Name Enter text (or use existing text) Name of the variable concerned
Unit Select signal type and unit
from the list (drop-down menu) Signal type and unit of the variable concerned
Display start -99999 to 99999
(
0 )
Lower limit of display range
Display end -99999 to 99999
(
100 )
Upper limit of display range
Parameter Selection/data input Description
Name Enter text (or use existing text) Name of the variable concerned