JUMO 705003, Operating Manual, Page: 77 / 112

77
5 Configuration
5.8 PLC configuration
5.8.1 Units
These settings are relevant for the automatic conversion performed when the temperature unit is
changed (°C/°F) (relates only to the PLC application).
5.8.2 Program generator
Nine independent program generators are available as an optional extra (extra code 225 required),
meaning that nine independent programs can run asynchronously at the same time.
The following description applies for program generators 1 to 9.
General
Parameter Selection/data input Description
Setting for abso-
lute temperature Unit for temperature value
°C Deg. Celsius
°F Deg. Fahrenheit
K Kelvin
Setting for rela-
tive temperature Unit for temperature difference
°C Deg. Celsius
°F Deg. Fahrenheit
K Kelvin
Parameter Selection/data input Description
Name of program
generator Enter text (or use existing text) Designation of program generator
Function Inactive The program generator is switched off.
Program generator The program generator is controlled by a program.
Fixed-setpoint generator The program generator operates as a fixed-set-
point generator. In this case, the setpoint values for
the basic status or manual mode are used.
Program start Program start The program starts at the first programmed set-
point value.
Actual value The program starts at the point at which the set-
point value corresponds to the current actual val-
ue.
Time A start time specified for program start is adopted
as the start time in a 24 h program.
Example:
Start time: 06:00:00; 24 h program from 00:00 to
24:00: The program starts at 6 a.m. and runs until
midnight.
Response by out
of range (O-o-R)
(behavior at O-o-
R) Behavior of the program generator if measuring
range is exceeded or if there is measuring range
underflow (Out-of-Range)
Continuation Program continues to run.
Program stop The program is stopped.