Thank you for purchasing this power protection product. It has been de-
signed and manufactured to provide many years of trouble free service.
Please read this manual before installing your SRA Series UPS, (SRA
07500, SRA 10000, SRA 15000, SRA 20000) as it provides important
information that should be followed during the installation and the main-
tenance of the UPS system allowing you to correctly set up your sys-
tem for the maximum safety and performance. Included is information
on customer support and factory service, if it is required. If you experi-
ence a problem with the UPS system please refer to the Troubleshoot-
ing guide in this manual to correct the problem or collect enough infor-
mation to assist technical support if that becomes necessary.
Veuillez lire ce manuel avant l'installation de l'onduleur modèles (SRA
07500, SRA 10000, SRA 15000, SRA 20000). Il contient de l'information
importante qui doit être respectée au cours de l'installation et de l'entre-
tien de l'onduleur et des batteries. Cette information vous permettra de
correctement installer le système pour atteindre son rendement maxi-
mum en toute sécurité.
CAUTION!
The maximum ambient operating temperature for this UPS
series is 40°C (“0 ~ 40°C” for Ambient Operation).
ATTENTION!
La température ambiante de fonctionnement maximale
pour cette série d'onduleurs est de 40° C ("0 ~ 40° C " pour une opération
ambiante).
The external vents and openings on the UPS are provided for venti-
lation. To ensure reliable operation of the UPS and to protect the UPS
from over- heating, these vents and openings must not be blocked or
covered. Do not insert any object into any of the vents or openings that
may hinder the ventilation.
Install the UPS system in a well ventilated area, away from excess
moisture, heat, dust, flammable gas or explosives.
Leave adequate space (at least 20cm) at the front and rear of
the UPS system for proper ventilation.
Do not mount the UPS system with its front or rear panel facing
down at any angle.
Before usage, you must allow the UPS system to adjust to room
temperature (20°C~25°C or 68°F~77°F) for at least one hour to
avoid moisture condensing inside the UPS.
IMPORTANT SAFETY INSTRUCTIONS SAVE
THESE INSTRUCTIONS !
CONSIGNES DE SÉCURITÉ IMPORTANTES
SAUVEGARDEZ CES CONSIGNES!
