INSTALLATION
This UPS series is
ONLY
intended to be installed in an indoor tem-
perature controlled environment that is free of conductive contaminants.
DO NOT operate the UPS in: extremely dusty and/or unclean areas,
locations near heating devices, water or excessive humidity, or where
the UPS is exposed to direct sunlight. Select a location, which will pro-
vide good air circulation for the UPS at all times. Route power cords
so they cannot be walked on or damaged. This UPS series is not in-
tended for use in a computer room as defined in the Standard for the
Protection of Electronic Computer/Data Processing Equipment
ANSI/NFPA 75. Typical battery life is 3 to 5 years. Environmental
factors do affect battery life. High temperatures, poor utility power, and
frequent, short duration discharges have a negative impact on battery
life.
Observe the following maximum environmental conditions:
Operating Temperature: 32F to 104F
Operating Elevation (above sea level): 0 to 10,000 ft
Relative Humidity: 95%, non-condensing
Storage Temperature: 5F to 113F
Be sure to read all instructions and cautions before installing the UPS.
Place the UPS in the final desired location and complete the rest of the
installation procedure.
These UPSs are shipped with the internal bat-
teries disconnected.
The batteries must be connected before putting
these UPSs into service. See the "Connecting the Batteries" proce-
dure to connect the batteries and then the "Rackmount Configuration"
to install the UPS into the rack. Use CAUTION: The UPS is heavy.
Use the appropriate number of personnel when installing the UPS.
CAUTION! Do not use the mounting brackets to lift the UPS. The
mounting brackets are only for securing the UPS to an equipment
rack.
ATTENTION! N'UTILISEZ JAMAIS LES SUPPORTS DE MONTAGE
POUR SOULEVER L'ONDULEUR.
Ces supports sont
uniquement
conçus pour fixer l'onduleur au rack
