REAR PANEL
1. The ten foot input power cord is for connecting the UPS to utility power.
Do
not use an extension cord with a UPS.
2. The input circuit breaker will trip in the event the load exceeds the UPS’s
power rating.
3. Coax connectors are for transient voltage surge suppression for
cable modem, CATV converter, DSS receiver or DVR.
4. The fan is for ventilation.
NOTE:
The fan only operates during the battery
mode and the AVR mode.
5. The USB Communications Port is for UPS monitoring and control.
6. The Battery Backup output receptacles. The output receptacles are
electrically wired into two segments to support the "Load Shed
ding Function" (Labeled Load 1 & Load 2).
7. The Always On Battery Backup output receptacles (Labeled Always
On) does not support the "Load Shedding Function".
NOTE:
The locking receptacle is only on the SRA 20000 model.
8. The option slot is for option cards.
9. The rackmount brackets are for mounting the UPS to the rack.
10. The RJ11/45 modular connectors are used for transient voltage surge
suppression for 10/100/1000 Base-T Network/single line
Phone/Fax/Modem.
11. The RJ11 EPO (Emergency Power Off) Port is for UPS control. This
connection is not for Telecommunication use.
Model #
Input Power Plug
Output Power Receptacles
SRA 07500
NEMA 5-15P
6 x NEMA 5-15R (Controlled)
2 x NEMA 5-15R (Unswitched)
SRA 10000
NEMA 5-15P
6 x NEMA 5-15R (Controlled)
2 x NEMA 5-15R (Unswitched
SRA 15000
NEMA 5-15P
6 x NEMA 5-15R (Controlled)
2 x NEMA 5-15R (Unswitched
SRA 20000
NEMA 5-20P
6 x NEMA 5-15/20R (Controlled)
1 x NEMA L5-20R (Unswitched
