Battery Power Line II User’s Manual DePuy Synthes Power Tools 23
Drill Chuck with Key, Drill Speed (530.730)
Drill Chuck with Key, Ream Speed (530.732)
•
Maximum speed:
– Drilling: approx. 930 rpm
– Reaming: approx. 340 rpm
•
Maximum torque:
– Drilling: approx. 6.0 Nm
– Reaming: approx. 15.0 Nm
•
Cannulation:
– Drilling: 3.2 mm diameter
– Reaming: 4.0 mm diameter
•
Accept round and triangular shafts
up to 7.3 mm diameter
Technical data is subject to tolerances.
Insert Instrument
Open the chuck jaws by turning the key (510.191)
counterclockwise, or by manually turning the collar
(Figure 1). Insert the instrument shaft into the
opened chuck.
Close the chuck manually by rotating the collar, keeping
the instrument shaft centered in the jaws. Tighten the
chuck by turning the key clockwise (Figure 2).
Note: To ensure secure fixation of the instrument, make
sure the toothed rims on the drill chuck and key are
not worn. Replace damaged or worn components.
Remove Instrument
Turn the key counterclockwise to open the jaws.
Remove the instrument.
Operating Instructions
Attachments for Battery Reamer/Drill II
Replacement key (510.191)
Figure 1
Figure 2
Drill Chuck (530.730)
Drill Chuck (530.732)
