Battery Power Line II User’s Manual DePuy Synthes Power Tools 31
Operating Instructions
Attachments for Battery Reamer/Drill II
Quick Coupling for Pins, Drill Speed (530.796)
•
Maximum speed: approx. 930 rpm
•
Maximum torque: approx. 6.0 Nm
•
Cannulation: 3.2 mm diameter
•
Dedicated attachment to fix knee replacement cutting
blocks with a pin (as shown on page 3)
•
Allows insertion and removal of 3.2 mm diameter
guide pins with round, triangular and flat shafts
Technical data is subject to tolerances.
Insert Guide Pin into Attachment
Insert a 3.2 mm diameter guide pin into the front of the
attachment (Figure 1).
Note: The attachment is spring-loaded to prevent the
guide pin from falling out.
Insert Guide Pin into Bone
Pull the attachment lever toward the drive unit to grip the
pin (Figure 2).
Set the mode switch on the drive unit to FWD (forward)
and press the trigger to insert.
Release the lever to reposition the attachment on the pin,
if required.
Remove Guide Pin from Bone
Slide the attachment over the pin.
Set the mode switch on the drive unit to REV (reverse).
Pull the attachment lever toward the drive unit to grip the
pin (Figure 2).
Press the trigger while pulling backward to remove the
pin from the bone.
Figure 1
Figure 2
