36 DePuy Synthes Power Tools Battery Power Line II User’s Manual
Operating Instructions
Battery Oscillator II (530.710)
Insert Saw Blade
Fully open the saw blade coupling by turning the
locking knob.
Insert an oscillating saw blade into the coupling.
Turn the locking knob in the opposite direction to secure
the saw blade. Tighten the locking knob (Figure 1).
Adjust Sawing Plane
Pull the sliding sleeve back and rotate the saw head to
adjust the sawing plane (adjustable through 360° in 45°
increments (Figure 2).
Release the sliding sleeve and turn the saw head slightly
until it locks in place.
Remove Saw Blade
Open the saw blade coupling fully by twisting the locking
knob and remove the oscillating saw blade (Figure 3).
Instructions for Handling Saw Blades
DePuy Synthes recommends using a new saw blade for
each operation to ensure that the saw blade is optimally
sharpened and clean.
The following risks are associated with used saw blades:
•
Thermal necrosis caused by excessive heat buildup
•
Infection caused by residues
•
Extended cutting time due to poor sawing performance
•
Potentially, splintering of the teeth or the saw blade
The use of irrigation fluid is recommended to cool the
cutting tools and prevent heat necrosis.
Check the cutting tools for wear and/or damage after each
use, and replace if necessary. For optimal performance
only use DePuy Synthes saw blades. These are optimized
to meet the specific requirements of the tool. Non-
DePuy Synthes saw blades can considerably reduce the life-
time of the system.
Figure 1
Figure 2
Figure 3
