31 DePuy Synthes Power Tools Battery Power Line II User’s Manual
Operating Instructions
Attachments for Battery Reamer/Drill II
Figure 2
Figure 3
Quick Coupling for Kirschner Wires and for Pins,
Drill Speed (530.791)
•
Maximum speed: approx. 930 rpm
•
Maximum torque: approx. 6.0 Nm
•
Cannulation: 4.0 mm diameter
•
Allows insertion and removal of Kirschner wires and
guide pins with diameters from 1.5 mm to 4.0 mm
diameter, in any length
Technical data is subject to tolerances.
Insert Kirschner Wire/Guide Pin into Attachment
Set the appropriate diameter range on the attachment adjusting
sleeve. To adjust, push in the head of the attachment (1) and
then turn to the required diameter (2) (Figure 1).
Insert the wire/pin into the front of the attachment (Figure 2).
Note: Adjust the working length by pulling in the
wire/guide pin. The attachment is spring-loaded to
prevent the wire/pin from falling out.
Insert Kirschner Wire/Guide Pin into Bone
Pull the attachment lever toward the drive unit to grip
the wire/pin (Figure 3).
Set the mode switch on the drive unit to FWD (forward)
and press the trigger to insert the wire/pin.
Release the lever to reposition the attachment on the
wire/pin, if required.
Remove Kirschner Wire/Guide Pin from Bone
Set the appropriate diameter range on the attachment adjusting
sleeve. To adjust, push in the head of the attachment (1) and
then turn to the required diameter (2) (Figure 1).
Slide the attachment over the wire/pin.
Set the mode switch on the drive unit to REV (reverse).
Pull the attachment lever toward the drive unit to grip
the wire/pin (Figure 3).
Press the trigger while pulling backward
to remove the wire/pin from the bone.
Turn (2)
Push (2)
Figure 1
