98
6.0-3
6.0-1
9
12
2
10
11
14
13
6.0-2
G
R
1
Operator’s Manual
Maintenance
carry out:
• Removal of accumulated grease and dirt with a dry
cloth.
• Restoration, using a suitable amount of grease of
the lithium soap type (WZ10 Oilshot grease), order
code: EAA0394G10A.
on the parts:
Figure 6.0-1
2) Vertical activation bar on tools
Every week
carry out:
• Wash with cold water and soap or non-aggressive
chemical detergents.
• Dust only the b
ead breaking disks and tool guards
with talc.
on the parts:
Figure 6.0-1
9) Plastic guards for lifter parts
10) Plastic guards on mount/demount tool
11) Bead breaker disks
12) Plastic guard on wheel holder base.
Perform the following:
• Clean with a dry cloth
• Restore a thin fi lm of protective oil
on the following parts:
-) Wheel clamping hub nut
13) Vertical slide cylinder rods on tools
14) Front lifter pneumatic cylinder rods
Figure 6.0-2
• Use compressed air or a hard brush to remove any
residue built-up on the microswitch (
1, Fig. 6.0-2
),
located on the base of the lower bead breaker.
Note
:
Do not press the micro excessively in order
to avoid compromising the calibration.
Figure 6.0-3
• Check that the lubrication unit is working properly.
One oil drop falling into the transparent cone
G
every
4-5 complete strokes of the bead breaker indicates
that the correct amount of oil is being dispersed in
the system. If necessary,
• Adjust the unit using the screw
‘R’
to correct the oil
fl ow so it is as indicated above.
Every day
Perform the following:
• Clean with a dry cloth
the following parts:
Figure 6.0-1
10) Mount/demount tool plastic guards
11) Bead breaker disks
• Clean with a dry cloth and compressed air.
QUADRIGA 1000/BB
Summary of Contents for QUADRIGA 1000
Page 118: ...118 QUADRIGA 1000 BB ...
Page 130: ...130 Note Note Hinweis QUADRIGA 1000 BB ...