Servomotor series JHN, JHQ, and JL – User Manual
Introduction
Jetter AG
10
1 Introduction
This document is part of the product documentation describing Jetter drive technology and must be
read and understood before using the motor. It contains important and safety-related information
for the proper use of the motor as intended. It also contains technical data and type designations
for synchronous servo motors by Jetter AG.
1.1 Target groups
This document is intended for specialists with appropriate qualifications.
The device may only be installed and commissioned by trained and qualified personnel who will
observe the standards DIN EN 50110-1 and DIN IEC 60364 in their work.
During the whole product life cycle, safe handling and operation of the device must be ensured. In
the case of missing or inadequate technical knowledge or knowledge of this document any liability
is excluded.
1.2 Availability of information
Make sure this document is kept at the ready in the vicinity of the product throughout its service
life.
For information on new revisions of this document, visit the download area on our website.
Start | Jetter - We automate your success.
This document is not subject to any updating service.
An overview of product documentation related to Jetter drive technology and where to find it is
described in chapters 1.4 Overview: Product-specific documentation related to Jetter AG motion
systems .
An overview of cross-product documentation and tools is described in chapters 1.5 Overview:
General product documentation and tools .
1.3 Warranty information
Your product has left our factory fully tested and ready to use.
The information on the nameplate applies to rated operating conditions.
Warranty claims only apply to Jetter AG products.
Any warranty claims for a complete system in combination with third-party products are excluded.
Repairs shall only be carried out by the manufacturer.
Warranty claims become void if the device is opened or if modifications are made.
