jcb ROBOT 150, Service Manual

Page: 49 / 254

10 - 4
Engine (cont'd)
Checking the Oil Level - JCB Diesel engine
-
for interval see Service Schedule
! !
WARNING
Hot oil and engine components can burn you. Make sure
the engine is cool before doing this job.
2-3-3-2
1 Park the machine on level ground and lower the
attachments to the ground.
2 Stop the engine and remove the starter key.
3 Open the engine compartment rear door and hinged top
cover.
4 Check that the oil level is within the marked area on the
dipstick
A .
5 If necessary, add the recommended oil through the filler
point
B .
6 Make sure the filler cap and the dipstick are secure.
7 Close and secure the engine compartment hinged top
cover and rear door.
Changing the Oil and Filter - JCB Diesel engine
- for interval see Service Schedule
! !
WARNING
Hot oil and engine components can burn you. Make sure
the engine is cool before doing this job.
2-3-3-2
1
Do Steps 1 to 2 of
Checking the Oil Level
.
2 Open the engine compartment rear door and top cover .
3 Access to the sump drain plug is through the chassis
blanking plate
C . Remove the blanking plate and place a
suitable container beneath the machine to catch the oil.
4 Remove the drain plug D and allow the oil to flow into the
container.
5 After emptying the sump, replace the drain plug D and
refit the blanking plate C .
Section 3
Routine Maintenance
9803/8500
Section 3
10 - 4
Issue 3*
S255840
A A
S256260
D D
B B
C C
*
*