jcb ROBOT 150, Service Manual

Page: 38 / 254

7 - 3
Electrics (cont'd)
Changing the Light Bulbs
Worklight Bulb
1 Support the light unit B remove screws A .
2 Lift and turn light unit B to gain access to connectors C
and D .
3 Disconnect at C and D .
4 Remove the bulb by releasing clips E .
5 Do not touch the new bulb with bare fingers. Fit the
new bulb.
6 Reassemble the light unit in the reverse order.
Cab Interior Light Bulb
1 Carefully lever light unit F from the roof, using a
screwdriver in the slot at one end.
2 Ease the spring contact G to release the bulb.
3 Fit new bulb. Make sure the bulb is seated in the spring
contact holes.
4 Refit light unit F , take care not to trap the wires.
Rotating Beacon Bulb
1 Remove the three screws H and remove cover J .
2
Release spring clip
K
and ease the bulb from its holder
L .
3 Disconnect the bulb at M .
4 Do not touch the bulb with bare fingers. Fit the new
bulb. Make sure that the bulb is seated correctly and the
spring clip
K is secure.
5 Reassemble the light unit in the reverse order.
Section 3
Routine Maintenance
9803/8500
Section 3
7 - 3
Issue 1
133010
132930
132970
A A
A A
B B
C C
D D
E E
F F
G G
J J
H H
H H
K K
L L
M M