IWILL dca200, Manual

Page: 68 / 83

Chapter 5 BIOS Setup
68
DCA200-N Series
5.6.12.1 RxD, TxD Active for IrDA and ASKIR functions
When setting the field to either IrDA or ASKIR, you must select the active
level of receiving and transmission signal.
Options
Hi, Lo (*) / Lo, Hi / Lo, Lo / Hi, Hi
5.6.12.2 IR Transmission delay for IrDA and ASKIR functions
When setting the field to either IrDA or ASKIR, you must select
whether or not you require a delay between IR transmissions.
Options
Enabled (*)
Disabled
5.6.12.3 IR Duplex Mode
Options Full
Half (*)
5.6.12.4 Use IR Pins
Options IR-Rx2Tx2 (*)
RxD2 , TxD2
5.6.13 Onboard Parallel Port
This field configures the onboard parallel port. There are several port addresses
and IRQ channels to select from.
Options Description
378 / IRQ 7(*) Port address 378h, IRQ 7
278 / IRQ 5 Port address 278h, IRQ 5
3BC / IRQ 7 Port address 3BCh, IRQ 7
Disabled Disables parallel port
5.6.14 Parallel Port Mode
This field configures the operating mode of an onboard parallel port. Ensure
you know the specifications of your parallel port devices before selecting field.
Options SPP (*) / EPP / ECP / ECP+EPP
5.6.14.1 EPP Mode Select
When the Parallel Port Mode field is configured as EPP, ECP+EPP mode,
the EPP version needs to be specified. Please refer to your peripheral
document before selecting field.
Options
Description
EPP1.7 Use EPP 1.7 protocol