Iveco NEW DAILY, Instructions Manual

Page: 147 / 240

NEW DAILY
–
ELECTRONIC SUB-SYSTEMS
ELECTRONIC SUB-SYSTEMS
5.2 BODY BUILDER CONNECTORS
11
–
Printed 603.95.789
–
1 Ed. - Base 02/2014
208224
Figure 7
1. Body builders connector
2. Separation diode REQUIRED
3. Interface responsibility of the designer of the processor
4. Signal processor
The body builder must install a special separation diode so as not to lower the V
ON
voltage.
The designer of the signal processor must ensure interface input equal to that represented with a max VCC voltage of 5 V and
"pull-up / pull-down" so as not to lower the V
ON
voltage and raise the response time set by the vehicle interface.
Specification 3
Cruise Control Commands via Body builder socket
The body builder must mount the divider outlined below by connecting the 20-pole body builder connector referring to the pins
indicated.
208225
Figure 8
Prescribed diagram for body builder platform
A. Pin 12 20-pin body builders connector
B. Pin 13 20-pin body builders connector (ground)
C. Pin 4 20-pin body builders connector (ground if V=0)
D. Pin 11 20-pin body builders con15)