Iveco NEW DAILY, Instructions Manual

Page: 238 / 240

22
NEW DAILY
–
DAILY CNG AND CNG WITH "RECOVERY MODE"
DAILY CNG AND CNG WITH "RECOVERY MODE"
B.5
FUSES AND RELAYS
–
Printed 603.95.789
–
1 Ed. - Base 02/2014
117715
Figure 22
●
Unscrew the nuts
(5)
and remove the cover
(4)
.
●
Disconnect the electrical connection
(1)
from the coil
(2)
of the VBE solenoid valve.
●
Disconnect the gas pipes
(3)
from the solenoid valve
(2)
.
●
Hold up the cylinder
(6)
with suitable support
(9)
.
●
Remove the screws
(7)
, turn the brackets
(8)
and remove the cylinder
(6)
from the chassis.
●
Remove the VBE valves
(2)
from the cylinder
(6)
as described in the corresponding chapter.
Refitting
To refit, carry out the removal operations in reverse order, observing the following instructions:
●
Place the cylinders in the framework with the VBE valves pointing in the right direction to allow connecting the pipes;.
●
tighten the VBE valves (2) and the pipe unions to the prescribed torque, observing the instructions given in the paragraph
”Repairs on pipes and fittings (
➠
Page 18)”.
●
Once refitting is completed, perform the hydraulic sealing test for leaks as indicated in the warnings at the beginning of
Chapter B.3 (
➠
Page 6).
B.5 FUSES AND RELAYS
Fuse and relay box under the CNG dashboard
See Chapter 5.4 .
B.6 CONNECTORS FOR BODY BUILDERS
Note For information about connectors for body builders, refer to the descriptions in Section 5 - Chapter 5.2 .