Electrical installation
Page 85
For highly flexible applications:
C 1-02:
LAPP KABEL ÖLFLEX SERVO FD 755 P; 4 G 1,5 + 2 x (2 x 0,75) CP;
∅
14,1 mm, with tinned total Cu shield for highly flexible
use in drag chains
C 1-05 and C 1-08:
LAPP KABEL ÖLFLEX SERVO FD 755 P; 4 G 2,5 + 2 x (2 x 0,75) CP;
∅
15,1 mm, with tinned total Cu shield for highly flexible
use in drag chains
8.4.5
Connection notes [X6]
PE (optional)
Motor Phase U resp. 1
Motor Phase V resp. 2
Motor Phase W resp. 3
BR-
BR+
MT+
MT-
Motor connector
PE (Motor)
Cable shield
(optional)
1
4
7
9
2
5
8
3
6
Connector housing
Motor housing
PHOENIX
MINI-COMBICON
at the X6
PHOENIX
COMBICON
at the X6
Figure 18:
Motor connection [X6]
PHOENIX MINI-COMBICON MC 1,5/ 9-ST-5,08 BK
PHOENIX COMBICON MSTB 2,5/9-ST-5,08 BK
Connect the inner shields to PIN 3; maximum length 40 mm.
Length of unshielded cores maximum 35 mm.
Connect total shield on controller side flat to PE terminal; maximum length 40 mm.
Connect total shield on motor side flat to connector or motor housing; maximum length 40 mm.
Via terminals ZK+ and ZK- the DC buses of several item servo positioning controller C 1-Series can be interconnected. The
coupling of the DC bus is interesting for applications with high brake energies or if movements have to be carried out even in
the case of power failure. For further information please refer to Application Note 67.
A holding brake can be connected to the terminals BR+ and BR- of the motor. The holding brake is fed by the servo positioning
controller’s power supply. Note the maximum output current provided by the item servo positioning controller C 1-Series. A
relay may have to be placed between the device and the holding brake as shown in
