Isuzu N Series 2008, Owner'S Manual

Page: 199 / 580

4-71
CONTROLS AND INSTRUMENTS
Windshield Wiper and Windshield Washer Switch
To use the windshield wiper and washer switches, the starter switch must be in the
"ON" position.
MFU8Z0SH017801
(High speed)
(Low speed)
(Intermittent)
(Off)
The windshield wiper switch has the
following positions, which correspond to the
states of the wiper.
Lever position
Wiper state Stopped
V
Intermittent
(Light rain)
Low speed
(Moderate rain)
High speed
(Heavy rain)
Windshield Wiper Switch
ADVICE
The safety system may work to stop •
the wiper when excessive load is
applied on the motor. In this case,
turn the switch to the "OFF" position
and, a few minutes later, check to
see if the wiper is back to normal
operation. If the wiper frequently
stops operation, refrain from using
it and contact the nearest Isuzu
Dealer.
Before operating the wiper, ensure
•
that the wiper rubber is not stuck
on to the windshield. If the wiper
rubber is stuck to the windshield and
you still operate the wiper, the wiper
may break or the wiper motor may
fail.
Do not operate the wiper on a dry
•
windshield surface. Otherwise, the
windshield surface may sustain
damage. Always use the windshield
washer when wiping a dry glass
surface.
2008N_sec04-1_print2.indd 71 3/09/2008 5:29:01 PM