Isuzu N Series 2008, Owner'S Manual

Page: 193 / 580

4-65
CONTROLS AND INSTRUMENTS
NOTE
Use low beam whenever there are •
vehicles ahead in the same lane or
oncoming vehicles in the opposite
lane.
When the Bulb Does not Come On
→ Refer to page 8-24
Switching between High and Low
Beams (Flash-to-Pass Signal)
By lightly pulling the light control switch
lever and releasing it, the high beam
comes on and off. At the same time, the
high beam indicator light on the instrument
panel comes on and off. Use this function
as a signal for flash-to-pass a vehicle or
other purposes.
When turning left or right, move the lever
up or down to flash the turn signal light.
Turn Signal Switch
ADVICE
The turn signal lights come on •
even when the starter switch is in
the "LOCK" or "ACC" position. Do
not operate the turn signal lights
for an extended time period with
the engine stopped. Otherwise,
the battery may go dead, making it
impossible to start the engine.
2008N_sec04-1_print2.indd 65 3/09/2008 5:28:56 PM