iES12G
User’s
Manual
UM-iES12G-1.72.2-EN.docx
Pages 137 of 166
© 2020 IS5 COMMUNICATIONS INC. ALL RIGHTS RESERVED
Selected Counters and Attached Clients
The Selected Counters table is visible when the port is in the MAC-based Auth. state.
The table is identical to and is placed next to the Port Counters table, and it will be empty if no MAC
address is currently selected. To populate the table, select one of the attached MAC Addresses (shown
as Attached Clients) from the table below.
Figure 131
–
Selected Counters / Attached Clients
Label
Description
MAC Address
For MAC-based Auth., this column holds the MAC address of the attached
client.
Clicking the link causes the client's Backend Server counters to be shown in
the Selected Counters table. If no clients are attached, it shows
“
No clients
attached
”
.
VLAN ID
This column holds the VLAN ID of the corresponding client that is currently
secured through the Port Security module.
State
The client can either be authenticated or unauthenticated. In the
authenticated state, it is allowed to forward frames on the port, and in the
unauthenticated state, it is blocked. As long as the backend server hasn't
successfully authenticated the client, it is unauthenticated. If an authentication
fails for one or the other reason, the client will remain in the unauthenticated
state for Hold Time seconds.
Last Authentication
Shows the date and time of the last authentication of the client (successful as
well as unsuccessful).
4.2
Warning
Fault Alarm
When any selected fault event happens, the Fault LED on the switch panel will light up and the electric
relay will signal at the same time. Select the events to cause the fault alarm, then click
Save
, to save the
