Communication extension card
EtherNet/IP communication card
-77-
5.
Perform ring network configuration.
The following describes how to implement a ring network between the PLC and
EtherNet/IP communication card. After device installation in the ring network, at least
one monitoring node must be configured. You can perform configuration on Studio
5000.
Note: The EtherNet/IP communication card does not support the ring network
monitoring function.
You need to use the PLC with the ring networking capability and at least two
EtherNet/IP communication cards (the suggested number is 32 at most in a DLR ring
network). For details about the connection method, see Figure 5-4 Electrical wiring
diagram for a ring network.
Note:
The PLC communicates with upper monitoring software by using the USB cable.
The configuration on the RSLinx and Studio software is similar to that described in the
preceding steps.
Assume that projects have been created, as shown in the following figure.
Download projects to the PLC. Enable the PLC online and start the programming mode
for it.
In
I/O Configuration
, double-click the module. In the
Controller Properties
window,
click the
Network
tab, choose
Enable Supervisor Mode
, and then click
OK
.
Summary of Contents for Goodrive350 Series
Page 1: ......
Page 104: ...Communication extension card EtherCAT communication card 99...
Page 135: ...66001 00600 202004 V1 2...
