International Trucks ProStar+ Eagle Series., Operator'S Manual

Page: 116 / 263

Sleeper Features
1. Bunk
2. Restraint Webbing System
3. Rear Latches
4. Rear Buckles
5. Font Latches
6. Front Buckles
7. Side Latch Plates
8. Side Buckles
9. Restraint Strap
To install the restraint webbing system onto the sleeper bunk:
1. Enter the bunk and lay the restraint webbing system out
on top of your body.
2. Insert two rear latches on the rear wall into two mating
buckles (4) that are sewn to the restraint webbing
system, making sure that both buckles are fully latched.
3. Insert three front latches that are sewn to the front of the
restraint webbing system into the front buckles mounted
at the front of the bunk, making sure that all three front
buckles are fully latched.
4. The restraint webbing system is designed to be held up
away from the reclining bunk occupant by the adjustable
side latch plates on each side of the restraint webbing
system. Insert two side latch plates that are sewn to the
restraint webbing system into the side mating buckles
located on the sleeper compartment side walls.
5. To adjust the restraint webbing system, pull the short
straps at the side latch plates on each side of the
restraint webbing system to tighten.
Loosen the
restraint webbing system by raising the side latch plates
away from the restraint strap to allow the restraint strap
to loosen through the latch plates.
6. Removal of the restraint webbing system is done by
loosening both side latch plates, unlatching the side
latch plates, unlatching the three buckles at the front of
the bunk, and unlatching the two buckles attached to
the rear wall.
104
3878859R2