Intermec CK1 Serial Dock, User Manual

Page: 16 / 147

Chapter 1 — Learning About the CK1
CK1 Handheld Computer User’s Manual 5
The CK1 has a button under the battery door that lets it know
when the battery door is removed. If the CK1 is on when the
battery door is removed, the CK1 turns off.
If you fail to replace the battery immediately, you may lose
important data or applications.
Attention: Si la batterie n’est pas remplacée immédiatement,
des données ou applications importantes risquent d’être
perdues.
Note: Do not press the Power key when there is no battery
installed in the CK1. If you turn on the CK1 without a battery,
you can lose data. For help finding the
Power key, see “Using
the Keypad” on page 11.
Charging and Installing the Battery
You must fully charge the battery before you can use the CK1.
To charge the battery
• Install the battery in the CK1, and place the CK1 in the
multi-dock, serial dock, or modem and connect the dock to
an external power supply. For help installing the battery in
your CK1, see the next procedure, “To install the battery.”
The battery takes about 4 hours to charge. For help, see the
CK1 Multi-Dock Quick Start Guide (P/N 073837), the
CK1 Serial Dock Quick Start Guide (P/N 073772), or the
CK1 Modem Dock Quick Start Guide (P/N 073773).
• Place the battery in the battery charger (P/N 073660). The
charger uses a charging method that maximizes battery life.
Charge the battery until the Charge Status light turns green
to ensure that it is fully charged. The battery takes about
4 hours to charge. For help, see the
CK1 Battery Charger
Quick Start Guide (P/N 073776).