148
Modification Buttons
You can modify each QCE (QoS Control Entry) in the table using the following buttons:
: Inserts a new QCE before the current row.
: Edits the QCE.
: Moves the QCE up the list.
: Moves the QCE down the list.
: Deletes the QCE.
: The lowest plus sign adds a new entry at the bottom of the QCE listings.
Buttons
Refresh :
Click to refresh the page. This will help to check the latest conflict status after releasing the
resources.
4.17.11 QoS / Storm Control Configuration
Storm control for the switch is configured on this page.
There is a unicast storm rate control, a multicast storm rate control and a broadcast storm rate control.
These only affect flooded frames; i.e., frames with a (VLAN ID, DMAC) pair not present on the MAC
Address table.
The configuration indicates the permitted packet rate for unicast, multicast or broadcast traffic across
the switch.
Note:
Frames, which are sent to the CPU of the switch are always limited to approximately 4 kpps. For
example, broadcasts in the management VLAN are limited to this rate. The management VLAN is
configured on the IP setup page.
Frame Type
The settings in a particular row apply to the frame type listed here: Unicast, Multicast or Broadcast.
Enable
Enable or disable the storm control status for the given frame type.
