Intel SRCU32 - RAID Controller, User Manual

Page: 64 / 182

64 Intel RAID Controller SRCU32 User’s Guide
New Installation of NetWare 4.2 and 5.1
The following procedures assume that the Intel RAID Controller SRCU32(s) is(are) already
installed in the system. If you plan to install the OS to a RAID volume, you must first configure the
RAID volume through the XROM version of StorCon. At system boot time, press <Ctrl> + <G>
when prompted to invoke the XROM version of StorCon.
✏
NOTE
Install all Novell patches and updates prior to installing the Intel RAID Controller SRCU32 driver
and StorCon. These updates can be found at:
http://www.novell.com
New Installation of NetWare 4.2 with the SRCRX.HAM Driver
1. Create a driver diskette from the RAID Software Suite CD-ROM. See Chapter 2 for details to
create this disk.
2. Start the OS installation from the NetWare CD-ROM. (NetWare 4.2 CD-ROMs are NOT
bootable so you must have a bootable DOS partition installed on the target hard drive and have
the appropriate DOS driver for the CD-ROM.)
3. At the driver summary menu select “modify drivers.”
4. Insert the driver diskette into drive A:
5. Press <Enter> on the SRCU32 driver list.
6. Press <Insert> in the SRCU32 controller driver menu.
7. Press <F3> and change the path to A:\DRIVERS\4XX then press <Enter>.
8. Select the SRCRX.HAM driver and complete the installation.
New Installation of NetWare 5.xx with the SRCRX.HAM Driver
1. Create a driver diskette from the RAID Software Suite CD-ROM. See Chapter 2 for details to
create this disk.
2. Start the OS installation from the NetWare bootable CD-ROM.
3. At the storage driver summary menu select “modify drivers.”
4. Insert the driver disk into drive A:
5. Press <Enter> on the storage driver list.
6. Press <Insert> in the storage controller driver menu.
7. Press <F3> and change the path to A:\DRIVERS\5XX then press <Enter>.
8. Select the SRCRX.HAM driver.
9. Complete the installation.