Intel
®
Server System R1000WF Product Family System Integration and Service Guide
87
2.
Install the control panel board into the chassis (see Letter “A”).
Note
: Ensure the plastic gasket over the control panel buttons is securely in place before installing the
control panel board into the drive bay module.
3.
Connect the 30-pin cable to the new control panel.
4.
The control panel is properly positioned when the buttons are protruding from the control panel face
plate on the front of the drive bay module and the screw holes on the top of the assembly are
aligned.
5.
Using a single screw, secure the Control Panel Assembly to the drive bay module (8 in/lb. torque) (see
Letter “B”).
6.
Connect the other end of the front panel cable to the matching 30-pin connector on the server board.
7.
Install system fan module assembly (see Section 7.1).
8.
Install air duct (see Section 2.3.2).
7.6
Replacing the Server Board
7.6.1
Server Board Removal
1.
Power off system and remove power cords from each power supply module.
2.
Disconnect all externally attached cables.
3.
Remove the system cover (see Section 2.2.1).
4.
Remove power supply modules (see Section 3.1.2).
5.
Remove air duct (see section 2.3.1).
6.
Disconnect all the system fan cables.
7.
Remove both fan module assemblies from the chassis (see Section 7.1
ound.
).
8.
Disconnect all cables attached to add-in PCIe* add-cards and I/O modules.
9.
Remove riser card assemblies (see section 2.7
Error! Reference source not found.
).
10.
Remove all options installed onto the server board including (if installed): OCP Module, Intel® SAS RAID
Module and mounting stand-offs, Intel® RAID 5 option key, Intel® RMM 4 Lite key, TPM Module, eUSB SSD
and mounting stand-offs.
11.
Remove Processors (see Section 1).
12.
Remove all DIMMs (see Section
Error! Reference source not found.
).
13.
Disconnect all cables attached to connectors on the server board.
