Intel
®
Server System R1000WF Product Family System Integration and Service Guide
57
5.
Remove the OCP bay filler from the chassis back panel. Squeeze the panels on each side of the filler and
push it out of the chassis.
6.
Remove the four (4) pre-installed screws from the mounting stand-offs (2 on the server board + 2 on the
chassis base)
7.
Carefully angle and insert the rear connectors of the IFT Carrier card into the cut-out on the chassis back
panel and position the card over the four stand-offs on the server board (see Letter ‘A’). Care should be
taken NOT to damage the I/O shield material when placing the card into the back panel cut-out
8.
Secure the IFT Carrier card with four screws as shown (see Letter ‘B’)
9.
Route the HFI cable attached to Port 1 of the IFT Carrier Card to CPU #1
Figure 83. Fabric Processor Cable Installation
10.
Place the HFI cable processor connector within the connector rails on the processor socket and slide
processor and cable connectors together (See Letter A)
11.
Pull the bail wire back until the cable is securely locked in place (See Letter B)
12.
Repeat Steps 8 thru 10 for the second internal HFI cable if present
13.
Connect the Omni-path sideband cable from the IFT Carrier card to the two sideband signal connectors
on the server board at the locations shown above.
Place and Insert Cable
Lock Cable
A
B
Omni-path Sideband Connector
Omni-path Sideband Connector
