— C:\Program Files\Java\jfx
Note: The unzipped folder name of JRE is
jdk-11.0.xx+x-jre
(for example,
jdk-11.0.15+10-jre
), you need to rename it to
jre
. The unzipped folder
name of JFX is
javafx-sdk-17.0.2
, you need to rename it to
jfx
.
2. On Linux system, Intel recommends you to unzip the files and rename the folders
using the following commands:
# unzip openjfx-17.0.2_linux-x64_bin-sdk.zip -d /opt/Java/
# tar zxvf OpenJDK11U-jre_x64_linux_hotspot_11.0.15_10.tar.gz -C /opt/Java/
# cd /opt/Java
# mv javafx-sdk-17.0.2 jfx
# mv jdk-11.0.15+10-jre jre
You have the following two directories on your Linux system:
— /opt/Java/jre
— /opt/Java/jfx
4.1.4. Install the Intel Quartus Prime Software
You need to install the Intel Quartus Prime software that can support the silicon on the
development kit. The recommended version can be found in the
README.txt
file
under
examples\board_test_system
directory. If you choose to install individual
files, you must install the Intel Agilex device support.
The BTS communicates over JTAG to a test design running in the FPGA. The BTS and
Power Monitor share the JTAG with other applications like the Nios
®
II Gen 2 JTAG
Debug Module and the Signal Tap Logic Analyzer. Ensure closing other applications
before you use the BTS, because the BTS is designed based on the Intel Quartus
Prime software.
The BTS relies on the Intel Quartus Prime software's specific library. Before running
the BTS, open the Intel Quartus Prime software to automatically set the environment
variable
QUARTUS_ROOTDIR
. Otherwise, you can change it through the Environment
Variables in System Properties on Windows. The BTS uses this environment variable to
locate the Intel Quartus Prime library.
4.1.5. Run BTS GUI
With the power to the board off, follow these steps:
1. Connect the USB cable to your PC and the board.
2. Ensure the development board switches and jumpers are set according to your
preferences. For more information, refer to the Factory Default Switch Settings
section.
3. Check the external modules' status: QSFP/QSFPDD/DDR4 DIMM.
4. Turn on the board power switch.
Note: To ensure operating stability, keep the USB cable connected and the board
powered on when running the demonstration application. The BTS cannot
run correctly unless the USB cable is attached and the board is powered on.
Navigate to the
<package dir>\examples\board_test_system
directory. The
BTS release folder includes the following files.
4. Board Test System
739942 | 2022.09.21
Intel
®
Agilex
™
F-Series FPGA (Two F-Tiles) Development Kit User Guide
14
