Ingeteam Ingecon mWind 2.5, Installation Manual

Page: 41 / 56

Screen 2
Vdc Voltage supplied by the wind generator to the inverter (V).
Idc Current supplied by the wind generator to the inverter (A).
Screen 3
Alarm Status of inverter alarms. The installer has instructions for the proper response to each alarm. Only the
ones mentioned in this manual may be of use to the user.
0000H No alarms.
0001H Insufficient input voltage.
0002H Grid frequency out of range.
0004H Grid voltage out of range.
0008H Overcurrent in the inverter bridge.
0010H Overcurrent in the AC/DC converter.
0020H Insulation fault.
0040H Grid overcurrent.
0080H Overtemperature.
0100H Bus overvoltage.
0200H Configuration change.
0400H Manual shutdown.
0800H HW error.
1000H Instantaneous grid overcurrent.
2000H Detection of island mode operation.
4000H Relay impedance out of range.
8000H Hardware fault alert.
The value displayed in “Alarm Inv” can be the result of the (hexadecimal) sum of two or more of the
values listed above.
For example: Alarm Inv 0006H means the grid frequency and voltage are out of range (0002H +
0004H).
NumInv Number allocated to the inverter through the menu accessible in the display for identifying
communications.
Code1 Unit operating code. This can be requested from Ingeteam’s customer services.
Code2 Unit operating code. This can be requested from Ingeteam’s customer services.
SN
Serial Number.
Screen 4
TotE Total energy (kWh) delivered by the inverter to the grid from the date it was manufactured. Recording
the serial number of the equipment marks the start of this power log.
T con Number of hours the inverter has been connected to the grid.
NumCon Number of grid connections made during all hours of operation.
Screen 5
ETotal Total energy (kWh) delivered by the inverter to the grid since the last time the counter was reset.
T con
Number of hours the inverter has been connected to the grid since the counter was last reset.
NumCon Number of grid connections since counter was last reset.
Screen 6
FW Ver. Unit firmware version.
DFW Ver. Unit display firmware version.
D. Boot Version of the display program enabling firmware housing.
AAY2000IKI04 41
Installation manual Ingeteam Power Technology, S.A.