Ingeteam Ingecon mWind 2.5, Installation Manual

Page: 3 / 56

Important safety precautions
This manual contains important instructions for the installation, handling and use of the following models:
Ingecon
®
μWind 2.5 TL Ingecon
®
μWind 2.5
Ingecon
®
μWind 3 TL Ingecon
®
μWind 3.3
Ingecon
®
μWind 3.3 TL Ingecon
®
μWind 5
Ingecon ® μWind 3.68 TL
Ingecon
®
μWind 3.8 TL
Ingecon
®
μWind 4.6 TL
Ingecon
®
μWind 5 TL
Ingecon ® μWind 6 TL
and any models derived from these.
This manual should be read carefully and kept in a safe place.
General warnings
The operations described in the manual may be performed only by qualified personnel.
The status of qualified personnel referred to in this manual will be, as a minimum, that which meets
all the standards, regulations and laws regarding safety applicable to the tasks of installing and oper-
ating this unit.
The responsibility for designating qualified personnel will always fall to the company to which the
personnel belong. It is necessary to decide which workers are suitable or not for carrying out specific
work to preserve their safety at the same time as complying with occupational safety legislation.
These companies are responsible for providing appropriate training in electrical equipment to their
personnel and for familiarising them with the contents of this manual.
All applicable safety-related legislation for electrical work must be complied with. Danger of electric
shock.
Compliance with the safety instructions set out in this manual or in the suggested legislation does
not imply exemption from other specific standards for the installation, place, country or other circum-
stances that affect the inverter.
Opening the door of the housing does not imply there is no voltage inside.
The risk of electric shock exists even after disconnecting from the grid, the wind generator and the
auxiliary supplies.
Only qualified personnel may open it, following the instructions in this manual.
In units which include an isolating switch, never switch from OFF to ON without first ensuring there
is no DC voltage entering the equipment.
As long as the wind generator receives wind, the DC cables will be live.
The entire manual must be read and understood in full prior to manipulating, installing or operating
the unit.
AAY2000IKI04 iii
Installation manual Ingeteam Power Technology, S.A.