For TL models, the distance between drilled holes will be as follows:
7,5
7,5
80
200
80
7,5
160
324
In models with transformers, it is the transformer which will be secured to the wall. The inverter will subsequently be
fixed to the transformer.
The three upper drilled holes are made first. The measurements to be used are shown in the figure. The bottom hole
must be made when the unit is suspended, as explained in Section “5.2. Fixing the unit to the wall”. The figure shows
the approximate distances between the horizontal line formed by the three upper drilled holes and where the bottom
hole will be. It also shows the approximate vertical distance to the level of the top edge of the inverter, which will
subsequently be attached to the transformer fixed to the wall.
100
100
257
478,61
O
10
2.2. Environmental characteristics
The environmental conditions for operation are:
Ambient conditions
Minimum temperature
-20 °C
Minimum surrounding air temperature
-20 °C
Minimum surrounding air temperature
70 °C
Maximum relative humidity without
condensation
95%
For further information see Chapter “3. Operating, conservation and transport conditions”.
2.3. EMC requirements
The Ingecon
®
μWind units are equipped with the necessary filtering elements to comply with EMC requirements for
industrial applications in order to prevent disturbances in other equipment outside the installation.
AAY2000IKI04
16
Installation manual
Ingeteam Power Technology, S.A.
Summary of Contents for Ingecon mWind 2.5
Page 1: ...Ingecon Wind Installation manual...
Page 55: ...Notes...
