Multitron Standard - Operating Manual
Operation
17 March 2021
Page
67
of
114
6.4.3
Activating and Deactivating Parameters
Activating Parameters
To activate a parameter, proceed as follows:
Procedure
1.
Press the
F
button (2) to select the parameter in question.
The right-hand display (1) will show the set setpoint for the pa-
rameter. If you do not input anything within 2 seconds, the dis-
play will alternate between the set setpoint and the message
OFF.
2.
Press the
On/Off
button (3) to activate the parameter.
The parameter will be activated immediately. The right-hand dis-
play will alternate between the current actual value for the pa-
rameter and the message
ON.
INFORMATION
When the “Speed” (
RPM) parameter is activated, the shaking pro-
cedure will start up immediately. As such, we recommend activat-
ing this parameter last of all.
INFORMATION
The parameters need a little time to reach their set setpoints. Until
they have done so, the notice
Hi or Lo will be displayed, depend-
ing on whether the actual value is higher or lower than the set-
point.
2
1
3
