Chapter 3 - Configuration scenarios
User Manual
R5000 series - Web GUI
91
3.1.
Introduction
This chapter provides step by step instructions for some basic configurations of
R5000 units.
3.2.
Setting up a basic PtP link
For this example, we have two R5000 units with the default factory configuration.
Step 1
In order to access each of the units, we have to make sure that there is network
connectivity between the PC used for the configurations and the units on their default
Ethernet IP address which is 10.10.20.1/24.
Step 2
Connect to the first unit using a Web browser and type any username and any
password in the corresponding fields.
Let’s use in this example “test” for both
username and password. After the authentication, a warning message pops up and
requests us to change these initial authentication credentials:
Figure 63 - Warning message
– setup system login & password
Step 3
In order to change the initial credentials,
we have to go to Basic Settings → System
Settings and fill in the “User Name” and “Password” fields with the permanent
authentication credentials.
Let’s use in this example “Node1” user name and “Infi1”
password for the first
unit and “Node2” user name and “Infi2” password for the
second unit.
In the same section, we set the
“Device Name” parameter for each unit. Let’s name
in this example
“Node1” the first unit and “Node2” the second unit:
