Cheetah Pregius Camera with 10 GigE Vision Interface – User Manual
October 8, 2020
Page
94
of
170
Rev 1.0
AcquisitionFrameRateEnable
Controls the acquisition frame rate/frame time. If this mode is
On, you can extend frame time beyond the free-running frame
time.
AcquisitionFrameTime
Allows you to set the actual frame time in microseconds. Changes
to
AcquisitionFrameTime
affect the
AcquisitionFrameRate
setting.
AcquisitionFrameRate
Allows you to set the acquisition rate (in Hz with a precision of
0.01 Hz) at which the frames are captured. Changes to
AcquisitionFrameRate
affect the
AcquisitionFrameTime
setting.
AcquisitionLineTimeEnable
Controls the acquisition line time. If this mode is On, you can
extend line time beyond the free-running line time.
AcquisitionLineTime
This feature sets the actual line time in pixel clocks (74.25MHz).
AcquisitionBurstFrameCount
Sets the
number of frames to acquire for each trigger.
CurrentExposureTime
This is a read-only feature providing a real-time monitor of the
camera exposure time in micoseconds.
CurrentFrameTime
This is a read-only feature providing a real-time monitor of the
camera output period in micoseconds.
TriggerMode
Enables or disables the triggering operation. A trigger initiates an
exposure then readout sequence. Triggers received prior to
completion of this sequence are ignored.
TriggerSoftware
The Start SW Trigger command instructs the camera to generate
one short trigger pulse to capture and read out one frame when
TriggerSource
is set to Software.
TriggerSource
Specifies the internal signal or physical input line to use as trigger
source. Options are Line1, Line2, PulseGenerator, and Software
(Software is a single frame capture using internal exposure
setting).
TriggerActivation
Sets the triggering edge to Rising or Falling.
TriggerOverlap
Sets trigger overlap mode to Off (default). If the camera receives
a trigger pulse while the previous trigger is still being processed,
the camera ignores this pulse.
TriggerDebounceTime
Sets the trigger signal de-bounce time. Subsequent trigger signals
coming to the camera within the de-bounce time interval are
ignored.
TriggerFilterTime
Specifies the minimum Trigger signal pulse width. Any pulse
shorter than the selected time is ignored.
TriggerDelay
Sets the delay time in microseconds between the trigger pulse
and the start of exposure.
