Cheetah Pregius Camera with 10 GigE Vision Interface – User Manual
October 8, 2020
Page
17
of
170
Rev 1.0
Hardware
This chapter contains the detailed information needed for the initial design-in process:
•
connector types, pin numbering and assignments
•
electrical connectivity and voltage requirements
•
mechanical drawings and cabling
•
optical and environmental information
C4440, C5440, C6440 Cameras
Connectivity
The back panel of the camera provides all the connectors needed to operate and control the
camera and an LED status indicator.
The camera provides the following connectors:
•
an open SFP+ slot providing data, control, and serial interface. The SFP+ slot accepts a
variety of transceiver modules, including Fiber 10GBase-R and copper 10GBase-T.
•
male 12-pin Hirose miniature locking receptacle #HR10A-10R-12PB(71) providing power
input and I/O interface. Use a female Hirose miniature locking plug #HR10A-10P-12S(73) on
the mating end of your I/O cable
•
a camera status LED indicator
•
USB type B programming/SPI connector for factory use only
•
the camera’s model and serial number
The camera transmits serialized video data output and communications over the 10 Gigabit
Ethernet interface with consistently low, predictable latencies. The network interface is
compatible with IP/Ethernet networks operating at 10 gigabits per second.
camera status LED
12-pin connector for power and I/O interface
connector for factory use
two Ethernet Link Status LEDs
open SFP+ slot
